User manual

ManualsBrandsCasio ManualsWatch1887

1887-1

Module No. 1887

TOUCH SCREEN PRECAUTIONS

The touch screen of this watch shows a button menu that lets you select the

function you want by simply pressing the correct on-screen button with your

finger.

• The button menu shows only the functions that are currently available in

the mode you are in. Buttons for unavailable functions are not displayed.

• Take care that you touch the part of the touch screen that contains the

button whose function you want to perform.

• The following illustrations show the correct way to press an on-screen

button.

Important!

• Never press the touch screen with a sharp object, which can damage the

screen. Use your finger only.

• The touch screen is installed on top of the glass. This type of construction

may produce a rainbow effect on the display. The appearance of such

phenomenon does not indicate any problem and there is no need for

concern.

• You may experience problems with touch screen operation if the watch is

left for a long time in an area subjected to temperatures above 60°C

(140°F).

• This watch is not water resistant, so avoid high humidity and direct contact

with water. Also, do not wear the watch during activities that may cause

you to sweat a lot.

• The touch screen becomes convex at high temperatures and high altitudes.

This watch can still be used normally, and the screen will become flat again

when the temperature or altitude return to normal.

Incorrect

Finger at an

angle pressing

too strongly.

Buttons

• If the digital display of your watch is continually changing, see

“AUTO DISPLAY FUNCTION” for information on how to stop it.

• Press

to change from mode to mode.

GENERAL GUIDE

• After you perform an operation (except for backlight operation) in any

mode, pressing

returns to the Timekeeping Mode.

• The animation area shows different animated characters and graphics,

depending on the mode and the operation being performed.

▼

Press

Animation area

Timekeeping Mode Telememo Mode

Stopwatch Mode Alarm Mode World Time Mode

Correct

Press straight down

on the screen with

your fingertip.

BACKLIGHT

The backlight uses an EL (electro-luminescent)

panel that causes the entire display to glow for

easy reading in the dark. The watch’s auto

light switch automatically turns on the backlight

when you angle the watch towards your face.

• The auto light switch must be turned on

(indicated by the auto light switch on

indicator) for it to operate.

Turning on the backlight manually

In any mode, press to illuminate the display for about two seconds.

• The above operation turns on the backlight regardless of the current auto

light switch setting.

• The backlight remains lit for about two seconds from the point you press

, even if it is already lit when you press . If you keep depressed for

five seconds, the backlight will automatically turn off.

About the Auto Light Switch

Turning on the auto light switch causes the backlight to turn on whenever you

position your wrist as described below.

• Avoid wearing the watch on the inside of your wrist. Doing so causes the

auto light switch to operate when it is not needed, which shortens battery

life.

Moving the watch to a position that is parallel to the ground and then tilting

it towards you more than 40 degrees causes the backlight to light.

• The backlight turns off in about two seconds, even if you keep the watch

pointed towards your face.

• The backlight may not light if the face of the watch is more than 15 degrees

off the parallel as shown below. Make sure that the back of your hand is

parallel to the ground.

• Static electricity or magnetic force can interfere with proper operation of

the auto light switch. If the backlight does not light, try moving the watch

back to the starting position (parallel with the ground) and then tilt it back

toward you again. If this does not work, drop your arm all the way down so

it hangs at your side, and then bring it back up again.

• Under certain conditions the backlight may not light until about one second

or less after turn the face of the watch towards you. This does not

necessarily indicate malfunction of the backlight.

Auto light switch on

indicator

Parallel to

ground

than 40

More than 15 degrees

too high

More than 15 degrees

too low

Parallel to ground

Summary of content (5 pages)

PAGE 1
Module No. 1887 1887-1 TOUCH SCREEN PRECAUTIONS The touch screen of this watch shows a button menu that lets you select the function you want by simply pressing the correct on-screen button with your finger. • The button menu shows only the functions that are currently available in the mode you are in. Buttons for unavailable functions are not displayed. Correct Incorrect Press straight down on the screen with your fingertip. Finger at an angle pressing too strongly.
PAGE 2
1887-2 Warning! • Never try to read your watch when mountain climbing or hiking in areas that are dark or in areas with poor footing. Doing so is dangerous and can result in serious personal injury. • Never try to read your watch when running where there is danger of accidents, especially in locations where there might be vehicular or pedestrian traffic. Doing so is dangerous and can result in serious personal injury.
PAGE 3
1887-3 To use index search to recall data Inputting new Telememo data 1. In the Telememo Mode, press or until the new data screen appears. • The new data screen is the one that is blank (contains no name and telephone number). • If the message FULL appears on the display, it means that memory is full. To store more data, you will first have to delete some of the data stored in memory. until the NAME appears 2. Hold down on the display. • After a few moments, NAME is replaced by a cursor.
PAGE 4
1887-4 Making a Zone Your Home Zone 1. In the World Time Mode, display the zone (city code) that you want to make your home zone. 2. To make the displayed zone (city) your for about one home zone, hold down second. • The zone with the HOME indicator is the home zone. • The time displayed in the Timekeeping Mode changes in accordance with the zone you select with the above procedure.
PAGE 5
1887-5 ABOUT THE BATTERY Should battery power drop below a certain level, display characters will appear dim, the backlight may fail to light, and the alarm may fail to sound. indicator will appear, and further operation will be impossible Also, the when you try to input or recall data in the Telememo Mode or when you try to scroll the World Time city codes. Should any or all of this happen, have the battery replaced as soon as possible.