User manual

— 2 —
5. While the Daily Alarm/Hourly Time Signal setting is selected, press B to change the
status in the following sequence.
Hourly Time
Signal only
Daily Alarm only
Both offBoth on
6. Press C while the Daily Alarm/Hourly Time Signal setting is selected. At this time, the
watch returns to the normal Alarm Mode.
• If you do not operate any button for a few minutes while a selection is flashing, the
flashing stops and the watch goes back to the Timekeeping Mode automatically.
To stop the alarm
Press any button to stop the alarm after it starts to
sound.
• If you stop the alarm by pressing A, the display is
not illuminated.
To test the alarm and select an alarm tone
In any mode, pull out the crown and press C to sound
the alarm. Each time you test the alarm, a different
alarm sounds. Note that you cannot test the alarm
when any time setting operation is being performed
(indicated by the flashing digits).
24
HOUR.
8
18
12
915
321
60
SEC.
1050
30
2040
60
M I N.
1545
30
A
B
C
Crown
ABOUT THE BACKLIGHT
Pressing A in any mode illuminates the display for about two seconds. If you hold down
A, the light automatically disappears after two seconds.
• The display is not illuminated while the hands are moving to 12 o’clock position during
the stopwatch operation.
• The backlight of this watch employs an electro-lumi-
nescent (EL) light, which loses its illuminating power
after very long term use.
• The watch emits an audible sound whenever the
display is illuminated. This is caused because the
EL light vibrates slightly when lit. It does not indi-
cate malfunction of the watch.
• Frequent use of the backlight shortens the battery
life.
24
HOUR.
8
18
12
915
321
60
SEC.
1050
30
2040
60
M I N.
1545
30
A
B
C