User manual

HAND SETTING MODE
Perform the following operation whenever the hand indicator does not
align properly with "0" when a One-Touch Timer operation is complete in
the Timekeeping Mode.
• Note that the hand indicator is not meant to be a precise indicator, and
so it may not align exactly with all the numbers on the scales.
• If you do not operate any button for a few minutes in the Hand Setting
Mode, the watch automatically returns to the Timekeeping Mode.
60
30
0
20
10
5
0
30
40
50
60
A
B
C
Hand indicator
To adjust the hand indicator
1. Press B while in the Hand Setting Mode.
• At this time, the digital display shows the message “0-SET” and the hand indicator moves to the
vicinity of the “0” marking.
2. Press A and C to move the hand indicator up and down until it correctly points to the zero marking.
3. After you finish adjusting the hand indicator, press B to return to the Hand Setting Mode.
Use this mode to view and delete data stored by Stopwatch Mode
operation.
• If you do not operate any button for a few minutes in the Data Recall
Mode, the watch automatically returns to the Timekeeping Mode.
To recall data from memory
1. While in the Data Recall Mode, press A to recall the oldest time stored
in memory.
• First the memory number appears on the display, followed by the time
display. Memory numbers are assigned automatically by the watch as
data is stored. REC 1 is always the oldest data stored in memory.
2. Press A to scroll forward through the data.
• If you press A while the newest data is shown, the oldest data
reappears on the display.
To delete data from memory
Caution!
The following operation deletes
ALL data stored in memory and cannot be undone!
1. While in the Data Recall Mode, press B and the display shows “CLEAR”.
2. Press A to clear all data stored in memory and return to the Data Recall Mode.
DATA RECALL MODE
60
30
0
20
10
5
0
30
40
50
60
A
B
C
Time (minutes, seconds,
1/100 seconds)
Hand
indicator
Memory number
765/1305-2