User Manual

Table Of Contents

The projector can be controlled by a computer or other external device by connecting the device to

the projector’s LAN port.

Supported External Devices

This projector supports all commands of PJLink Class1 (Version 1.00).

http://pjlink.jbmia.or.jp/english/

This projector is supported by the commands of the Crestron Electronics controller and software

(RoomView

http://www.crestron.com/

This projector is supported by AMX Device Discovery.

http://www.amx.com/

Information about the types of external devices that can be connected to the LAN port and control the

projector, as well as the control commands supported for each external device will be published on

the CASIO website below as such information becomes available.

http://www.casio.com/support/

Controlling the Projector from a Computer

When the projector is linked to a computer over a wired or wireless LAN connection, you can use the

computer’s Web browser to access a Wireless Presentation System control panel to control the

projector.

To establish a wired LAN connection between the projector and a computer

Connect the LAN port of the projector to the LAN hub or other network devices

to which the computer is connected.

z In a configuration like the one in the illustration above, you should normally use straight type

LAN cables. If you are connecting the projector’s LAN port directly to the LAN port of a

computer, use a cross type LAN cable.

Using Wired LAN to Control the Projector

(XJ-H1650, XJ-H1750, XJ-ST145, XJ-ST155)

Projector

Computer

LAN hub