User Manual

E-53
Items Included
Attaching the Hand Belt
Attach the hand belt as described below.
1.Turn the IT-600 over.
Using Hand Belt (HA-D95HB2)
• Hand Belt • Strap • Screws (3 pcs)
Important!
• Before loading the IT-600 with the hand belt
attached onto cradle, loosen the belt as shown
in the figure so that it does not get caught
between the IT-600 and the cradle.
2. Attach the hand belt on the back of the
IT-600 and fasten the enclosed screws
(3pcs).
3. Attach the strap using the strap hole
in the bottom of the IT-600.
4. Feed the hand belt through the strap,
fold it back and secure it with the
Velcro fastener. Adjust the belt to a
comfortable length.
5. You can also use the strap to hold
the stylus when required, as shown
in the figure.