User Manual

E-27
Using the Linear Imager
1.After turning on the power, position the reader port close to a bar code and then press
the trigger key.
2.The LED emits light and scans the bar code. When scanning is completed normally,
Indicator 2 displays a green light and a buzzer sounds.
Important!
• If you are unable to scan a bar code, try changing the angle at which the
Handheld Terminal is held or distance between the reader port and the bar
code, and then try scanning again.
• This Handheld Terminal is capable of scanning bar codes at a distance of
about 60-300 mm (2
6
/
16
"-11
13
/
16
"). Furthermore, the distance at which
scanning is possible may vary according to the bar code symbology.
Warning!
■ Never look directly into the LED light.
• This product scans using LED light. Never look directly into the LED light
or shine the LED light into the eyes.
About the Class 1 LED Label
• This label identifies the Handheld Terminal as a Class 1 LED product under
IEC60825-1 (ed.1.2)