User's Manual

145
Appendix
Display Messages
Access timed out.
Connection
dropped.
Appears when a connection could not be established with a
smartphone.
Battery is low.
This message appears when the camera or controller battery
goes dead.
Camera
connection was
lost. Power will
turn off.
A Bluetooth connection between the camera and controller
could not be established or maintained (page 143).
Card ERROR
There is something wrong with the memory card. Turn off the
camera, remove the memory card and then reload it into the
camera. If this message re-appears when you turn the
camera back on, format the memory card (page 107).
IMPORTANT!
• Formatting a memory card deletes all its files. Before
formatting, try transferring recoverable files to a computer
or some other storage device.
File could not be
saved because
battery is low.
Camera’s battery power is low, so an image file could not be
saved.
Folder cannot be
created.
You are trying to record a file while there are already
9999 files stored in the 999th folder. If you want to record
more, delete files you no longer need (page 36).
Memory Full
Memory is full with images you recorded and/or files saved
by editing operations. Delete files you no longer need (page
36).
Overheating.
Power will turn off.
The camera protection function may have activated because
camera and/or controller temperature is too high.
Turn off power and wait until the camera or controller cools
down before trying to use it again.
The file could not
be created.
A Highlight Photo or Highlight Movie could not be generated
because there are not enough applicable images.
There are no files. There are no files in built-in memory or on the memory card.
This file cannot be
played.
The file you are trying to access is corrupted or is a type that
cannot be displayed by this camera.
This function
cannot be used.
This message will appear part way through an operation
when you attempt to use a function that is not allowed in
combination with another function.