User's Manual
Table Of Contents
- Accessories
- Read this first!
- Contents
- General Guide
- Monitor Screen Contents and How to Change Them
- Quick Start Basics
- Recording Images
- Advanced Recording Settings
- Recording Beautiful Portraits (Make-up)
- Using Touch Shutter (Touch Shutter)
- Changing the Image Size (Image Size)
- Specifying the Maximum Movie Recording Time (Max Recording Time)
- Shooting with Brightness Compensation (EV Shift)
- Adjusting Hue when Shooting (White Balance)
- Enabling Auto Rotation of Images to Match Camera Orientation (Auto Rotate)
- Viewing Snapshots and Movies
- Play Mode Screen
- Viewing Snapshots
- Viewing a Movie
- Deleting Snapshots and Movies
- Zooming an On-screen Image
- Viewing the Image Menu
- Rotating an Image (Rotation)
- Creating a Collage of a Day’s Snapshots (Highlight Photo)
- Creating a Movie of a Day’s Images (Highlight Movie)
- Changing the Highlight Score of an Image
- Connecting the Camera with a Smartphone (Wireless LAN)
- Other Settings (Set Up)
- Configuring Camera Sound Settings (Camera Sound)
- Using the Vibration Function (Vibration)
- Controller Startup Using a Flick Operation (Flick Start)
- Setting the Camera’s Clock (Adjust)
- Specifying the Date Style (Date Style)
- Specifying the Display Language (Language)
- Formatting Built-in Memory or a Memory Card (Format)
- Resetting the Camera to Factory Defaults (Reset)
- Printing
- Using the Camera with a Computer
- Appendix
87
Appendix
. Cleaning Your Camera after Use
Perform the following steps to clean the camera after using it under water or after it
becomes soiled with sand, dirt, or mud. Note that the [CARD] cover and [USB] cover
must be closed securely when performing these steps.
1. Immerse the camera in fresh water.
• Fill a bucket or other container with tap water or other fresh
water, and immerse the camera for about 10 minutes.
Gently wipe dust, dirt, sand, and other matter from the
camera with your fingers.
• Do not rub the lens surface or monitor screen while dirty.
2. Wipe the camera dry.
• Use a clean, dry, soft cloth to wipe off the camera, and leave it in a shady place
to dry.
IMPORTANT!
• The temperature of the water used to wash the camera should be no greater than
30
°C. Never use detergent, hot water, or strongly running water to clean the
camera. Doing so creates the risk of leaking and malfunction.
• Never swing the camera around to remove water, and never use a dryer or other
intense heat to dry it.
• Never place the camera in a washing machine to wash it.
. Precautions after Use
• Do not leave the camera in an area exposed to extreme heat (40°C or greater) or
cold (
–10°C or lower). Doing so can cause loss of waterproofing.
• Never use chemical agents for the purpose of cleaning, rust proofing, moisture
proofing, etc. Doing so can cause loss of waterproofing.
• Use fresh water to clean the camera within 60 minutes after using it underwater.
Failure to do so can cause deterioration of the exterior finish and waterproofing
properties.
• In order to maintain waterproofing, replacement of the camera’s gaskets is
recommended once each year. Note that you will be charged for gasket
replacement. Contact a CASIO authorized service center or your original retailer
for gasket replacement.