User's Manual
Table Of Contents
- Accessories
- Read this first!
- Contents
- General Guide
- Monitor Screen Contents and How to Change Them
- Quick Start Basics
- Recording Images
- Advanced Recording Settings
- Recording Beautiful Portraits (Make-up)
- Using Touch Shutter (Touch Shutter)
- Changing the Image Size (Image Size)
- Specifying the Maximum Movie Recording Time (Max Recording Time)
- Shooting with Brightness Compensation (EV Shift)
- Adjusting Hue when Shooting (White Balance)
- Enabling Auto Rotation of Images to Match Camera Orientation (Auto Rotate)
- Viewing Snapshots and Movies
- Play Mode Screen
- Viewing Snapshots
- Viewing a Movie
- Deleting Snapshots and Movies
- Zooming an On-screen Image
- Viewing the Image Menu
- Rotating an Image (Rotation)
- Creating a Collage of a Day’s Snapshots (Highlight Photo)
- Creating a Movie of a Day’s Images (Highlight Movie)
- Changing the Highlight Score of an Image
- Connecting the Camera with a Smartphone (Wireless LAN)
- Other Settings (Set Up)
- Configuring Camera Sound Settings (Camera Sound)
- Using the Vibration Function (Vibration)
- Controller Startup Using a Flick Operation (Flick Start)
- Setting the Camera’s Clock (Adjust)
- Specifying the Date Style (Date Style)
- Specifying the Display Language (Language)
- Formatting Built-in Memory or a Memory Card (Format)
- Resetting the Camera to Factory Defaults (Reset)
- Printing
- Using the Camera with a Computer
- Appendix
21
Quick Start Basics
IMPORTANT!
• The first time you connect the camera or controller to your computer with the USB
cable, an error message may appear on your computer. If this happens, disconnect
and then reconnect the USB cable.
• A battery that has not been used for a long time, certain types of computers, and
connection conditions can cause charging to take more than approximately five
hours, which will trigger a timer that terminates charging automatically, even if the
battery is not fully charged. If this happens, disconnect and then reconnect the
USB cable to restart charging. To complete charging faster, use of the included
USB-AC adaptor is recommended.
• If the battery has not been used for a very long time, charging of the controller may
stop after about 60 minutes or charging of the camera may stop after about
40 minutes. In both cases, the operation lamp will flash red. In either case, use of
the USB-AC adaptor that comes with the camera is recommended.
• Turning on the camera or controller while it is being charged by a computer results
in one of the conditions described below. Though charging normally should
continue, certain types of computers or connection environments may stop
charging if supply power is low. This will be indicated by the camera’s operation
lamp lighting green.
Camera:
Charging continues, and a USB connection will be established between computer
and camera.
Controller:
Charging continues and the controller turns on.
• Charging is not performed while the connected computer is in the hibernate mode.