User's Manual
78
Connecting the Camera with a Smartphone
(Wireless Connection)
Auto Send (page 83) will be turned on after you configure wireless connection
settings on the camera and smartphone.
After the camera is paired, Bluetooth wireless technology operation will consume
battery power even when the camera it turned off. Because of this, it is
recommended that you charge the cameras battery before you plan to use it.
Removing the cameras battery will terminate the Bluetooth wireless technology
connection. However, the connection will be re-established when you load a
battery into the camera and turn on the power again.
Smartphone that does not support Bluetooth Smart
Configure smartphone wireless LAN connection settings (input the camera SSID and
password).
1. Touch the (Wireless) icon.
2. Touch Shoot with phone.
3. Touch Start.
This will enable connection with a smartphone and the
camera will display a screen for input of an SSID and
password.
4. For the smartphone Wi-Fi setting, input the
camera SSID: and Password:.
When the message Start up the phone app. appears on
the cameras monitor screen, it means that the
smartphone has established a wireless connection with the camera. Starting up
EXILIM Connect will cause the cameras Wireless LAN connection lamp to light.
What you need to do to establish a wireless LAN connection depends on the
type of smartphone you are using. For details about how to establish a wireless
LAN connection see the user documentation that comes with your smartphone.
After you finish configuring camera and smartphone connection settings, you can
use the procedure below to establish a wireless LAN connection between the
camera and smartphone.
Turn off the camera.
On the camera, while holding down [] (Movie), hold down [] (Power) for
about one second.
On the smartphone, select the cameras SSID.
SSID
Password