User's Manual

19
Quick Start Basics

 Applying a commercially available LCD protective sheet will reduce the operation
sensitivity of the monitor screen.
 The camera will have a hard time interpreting a screen operation made using your
fingernails. Use the fleshy pad of your finger.
The camera and the controller each have a built-in rechargeable lithium ion battery.
The batteries are not charged when you purchase the camera, so you will need to
charge both the camera and controller before using them.
You can use either of the two following methods to charge the batteries.
 USB-AC adaptor
 USB connection to a computer (Using the included micro USB cable.)
 To charge with the USB-AC adaptor
While the camera and controller are turned off, connect in the sequence shown
below.
Charging time: Approximately X hours XX minutes
 When disconnecting the USB-AC adaptor from the camera, be sure to disconnect
from the camera first.

 If you turn on the camera or controller while charging with the USB-AC adaptor,
you will be able to perform normal recording operations. In this case, however,
charging of the camera will be stopped while it is turned on.
First, charge the battery prior to use.
USB-AC adaptor
(AD-C53U)
When plugging in the connectors, orient this marking as described below.
Camera : Towards the lens side
Controller: Towards the monitor screen side
[USB] port
Micro USB cable
(included with camera)
Power cord
[USB] cover