User's Manual

E-40
Configuring DIP Switch Settings
A bank of DIP switches is located under the side cover of the Bridge Satellite Cradle.
You can change the on/off settings of the DIP switches to configure the Bridge Satellite
Cradle to meet your needs. After you change DIP switch settings, the new settings do
not go into effect until you turn the Bridge Satellite Cradle off and then back on again.
12345678
Not used (Always off)
Not used (Always off)
Host Computer Interface
Setting
RS-232C
USB
6
OFF
ON
Setting
Intermediate Unit
Daisy Chain Disabled/Termination
5
OFF
ON
Setting
Host Computer
Daisy Chain
3
OFF
ON
4
OFF
OFF
Daisy Chain
Connection Type
Setting
115,200bps
*Initial factory default setting
1
ON
2
OFF
Bridge Satellite Cradle Data Rate
*
*
*
*
Important!
Note that other DIP settings are used for testing and inspection purposes. Because
of this, you should never use any DIP settings other than those described above.