Specifications

R
&S
F
S-K40 Remote Control
Software Manual 1161.8209.42 - 04 83
DISPlay[:WINDow<1|2>]:TRACe<1…3>:Y[:SCALe] <numeric_value>
This command defines the display range of the Y-axis (level axis) in the selected
measurement window. The numeric suffix in TRACe<1 to 3> is irrelevant.
Example
DISP:WIND:TRAC:Y?
'Returns the current Y Axis range in use
Characteristics
*RST value: 100 dB
SCPI: device-specific
DISPlay[:WINDow<1|2>]:TRACe<1…3>:Y[:SCALe]:AUTO
This command switches automatic scaling for the Y axis on and off. Using the
ONCE setting with this command causes automatic scaling to be performed
immediately, regardless of whether automatic scaling is switched on.
The numeric suffix at WINDow<1|2> and TRACe<1 to 3> are irrelevant.
Example
DISP:WIND:TRAC:Y:SCAL:AUTO 1
'Switches on automatic Y axis scaling
Characteristics
*RST value: 1
SCPI: device-specific
3.6 FETCh Subsystem
The FETCh subsystem contains commands for reading out results of complex
measurement tasks. This subsystem is closely linked to the CONFigure and SENSe
subsystems.
FETCh:PNOise:RFM?
FETCh:PNOise:RPM?
FETCh:PNOise:RMS?
FETCh:PNOise:RFM?
This command returns the measured Residual FM result for the specified trace.
Example
FETC:PNO1:RFM?
'Returns the Residual FM result for Trace1
Characteristics
*RST value: -
SCPI: device-specific