Specifications

R
&S
F
S-K40 Remote Control
Software Manual 1161.8209.42 - 04 74
CALCulate:LIMit<1 to 8>:LOWer:SHIFt <numeric_value>
This command shifts a limit line by the indicated value in Y-direction. The line is
shifted by modifying the individual y values
Example
CALC:LIM3:LOW:SHIF 20DB
'Shifts all Y values of limit line 3 by 20 dB.
Characteristics
*RST value: -
SCPI: device-specific
This command is an event and is therefore not assigned an *RST value and has
no query.
3.3.3.4 CALCulate:LIMit:UPPer Subsystem
The CALCulate:LIMit:UPPer subsystem defines the upper limit line. Note that if a set
command is issued in this subsystem the limit line effected is automatically converted
to an upper limit line.
CALCulate:LIMit<1 to 8>:UPPer[:DATA <numeric_value>,<numeric_value>...
CALCulate:LIMit<1 to 8>:UPPer:SHIFt <numeric_value>
CALCulate:LIMit<1 to 8>:UPPer:STATe ON | OFF
CALCulate:LIMit<1 to 8>:UPPer[:DATA <numeric_value>,<numeric_value>...
This command defines the values for the upper limit lines independently of the
measurement window.
The number of values for the CONTrol axis and for the corresponding UPPer
and/or LOWer limit line have to be identical. Otherwise default values are entered
for missing values or unnecessary values are deleted.
The unit must be identical with the unit selected by CALC:LIM:UNIT. If no unit is
indicated, the unit defined with CALC:LIM:UNIT is automatically used.
Example
CALC:LIM2:UPP -10,0,0,-10,-5
'Defines 5 upper limit values
for limit line 2 in the preset unit.
CALC:LIM2:UPP?
'Outputs the upper limit values for limit line 2 separated by
a comma.
Characteristics
*RST value: -
SCPI: conforming