Specifications

R
&S
F
S-K40 Measurements & Settings
Software Manual 1161.8209.42 - 04 62
CONTINUOUS SWEEP
The CONTINUOUS SWEEP softkey activates the continuous sweep mode. The next
measurement sweep activated (using the RUN hotkey) will run in continuous mode
Remote INIT:CONT ON
SINGLE SWEEP
The SINGLE SWEEP softkey activates the single sweep mode. The next measurement
sweep activated (using the RUN hotkey) will run in single sweep mode.
If the SINGLE SWEEP softkey is pressed whilst a continuous measurement is running
then the measurement will abort at the end of the current sweep.
Remote INIT:CONT OFF
SWEEP COUNT
The SWEEP COUNT softkey activates the entry of the number of sweeps
used for averaging. The allowed range of values is 0 to 32767.
In the continuous sweep mode averaging is performed until the set number of sweeps
is attained and is then continued as running averaging.
The default setting is 0. The number of sweeps used for averaging is applied to all
active traces.
Remote SENS:SWE:COUN
GENERAL SETTINGS
The c softkey deactivates the display while a single sweep is being performed. Once
the sweep has been completed the display is reactivated.
Remote INIT:DISP OFF