Specifications

R
&S
F
S-K40 Measurements & Settings
Software Manual 1161.8209.42 - 04 57
Fig. 21 Trace Menu
SELECT TRACE
When the SELECT TRACE softkey is pressed, the Select Trace pop-up dialog is
displayed. Up to 3 traces can be selected. The selected trace will be the active trace
for selecting the trace mode (Clear / Write, Average, View, Blank).
Remote --
CLEAR/WRITE
The CLEAR/WRITE softkey activates the overwrite mode for the collected
measured values for the active trace, ie the trace is overwritten by each sweep.
Remote DISP:WIND1:TRAC1:MODE
MAX HOLD
The MAX HOLD softkey activates the maxhold mode for the collected measured
values for the active trace, ie the maximum value of each point in the trace is
determined over the requested number of sweeps.
Remote DISP:WIND1:TRAC1:MODE
AVERAGE
The AVERAGE softkey activates the trace averaging function for the active trace.
The averaging is performed over the requested number of sweeps for single sweep mode.