Specifications

R
&S
F
S-K40 Measurements & Settings
Software Manual 1161.8209.42 - 04 53
2.4.4.1 RBW
The RBW parameter sets all the RBW settings in the Carrier Frequency Offset table to
a proportion of the start frequency for each sub-band. The resulting RBW is rounded to
the nearest 1/3/10 steps.
2.4.4.2 Average
The Average parameter sets all the Average settings in the Carrier Frequency Offset
table to the specified value.
2.4.4.3 FFT
The FFT parameter sets all the FFT settings in the Carrier Frequency Offset table to
the specified value.
Note that only those sub-bands where FFT filters are available will have FFT filters
enabled if this parameter is switched on.
2.5 Markers
This section of the user manual describes the Marker facility of the option. The markers
are used for marking points on traces, reading out measurement results and for quickly
selecting a display section. R&S FS-K40 provides four markers. All markers can be
used either as markers or delta markers.
The marker that can be moved by the user is defined in the following as the active
marker.
The MKR hardkey brings up the marker softkey menu. Any settings views on display
when the marker softkey menu is displayed shall be closed.