Specifications

R
&S
F
S-K40 Measurements & Settings
Software Manual 1161.8209.42 - 04 51
2.4.1 Sweep Mode Settings
2.4.1.1 Sweep Mode
When the Sweep Mode parameter is set the Carrier Frequency Offset Table gets updated
from the instruments default settings .
The possible values of the Sweep Mode parameter are:
Fast Not averaged. The measurement runs very fast. As the average column is
set to 1 for all sub-bands.
Normal Normal averaged. The measurement runs slower then the fast mode, but
thesub-bands are averaged more.
Averaged
Highly averaged. The measurement runs very slow with high average in
each sub-band for more accurate results.
Manual The RBW, Average and FFT columns can be set by the user.
In fast, normal and avaeraged modes, the table is not editable, it is information only.
2.4.2 Span Settings
2.4.2.1 Start Offset
Start Offset Defines the start frequency of the measurement.
When this parameter changes the X-axis Start parameter in General Settings (Noise) view
gets updated accordingly.
The Carrier Frequency Offset Table is highlighted to show the selected span for the
noise measurement.
2.4.2.2 Stop Offset
Stop Offset – Defines the stop frequency of the measurement.
When this parameter changes the X-axis Stop parameter in General Settings (Noise) view
gets updated accordingly.
The Carrier Frequency Offset Table is highlighted to show the selected span for the
noise measurement.