Specifications

R
&S
F
S-K40 Measurements & Settings
Software Manual 1161.8209.42 - 04 48
The Eval From setting cannot be set higher than the To settings
Remote CALC1:EVAL:STAR
2.3.6.3 To
To specifies the end of the measurement range for which residual calculations are to
be performed
The minimum value that can be specified for the To setting is the value of the X Axis
Start setting
The maximum value that can be specified for the To setting is the value of the X Axis
Stop setting
When the X Axis Start or X Axis Stop settings are modified the Eval From will be
automatically adjusted to ensure that it is not outside the measurement range
The To setting cannot be set lower than the Eval from settings
Remote CALC1:EVAL:STOP
2.3.7 Spot Noise Settings
The Spot Noise settings allows up to 4 discrete frequency points to be specified where
the Phase Noise result from a measurement sweep can be obtained and displayed.
Spot Noise results are updated whilst a sweep is running.
2.3.7.1 Enable
The Enable settings allows spot noise calculations to be switched on and off
Remote CALC1:SNO1:STATE ON
CALC1:SNO:AOFF