Specifications

R
&S
F
S-K40 Measurements & Settings
Software Manual 1161.8209.42 - 04 41
2.3 General Settings
This section of the user manual describes the General Settings view where all settings
related to the overall measurement can be modified, that is the Signal Characteristics,
Display settings, Trace settings, Residual calculation settings and spot noise settings.
GENERAL SETTINGS
The GENERAL SETTINGS softkey brings up the General Settings view.
Fig. 17 General Settings view
The parameters within the General settings view are logically grouped together into:
F Signal Settings
F AFC Settings
F Display Settings
F Trace Settings
F Residual Calculations
F Spot Noise Settings
F Analyser Settings
Any parameters that are not available for editing will have a grey background. This usually
occurs when one parameter setting makes another parameter invalid, for example if the
Verify Frequ ency and L ev el is switched off then none of the parameters below this (Frequency
Tolerance and Level Tolerance) have any meaning, so these parameters are greyed out.
When a particular parameter is selected within the General Settings view the status bar
changes to display information about the valid settings for the selected parameter.