Specifications

R
&S
F
S-K40 Measurements & Settings
Software Manual 1161.8209.42 - 04 40
2.2 Measurement results
The tabular section below the title bar shows the overall measurement settings used to
obtain the current measurement results.
Fig. 16 Overall measurement settings summary
The settings summary includes the following information:
3. Signal Frequency The frequency of the measured input signal.
Signal Level The level of the input signal
Signal Freq
T Shows the measured frequency difference (During
verification & tracking)
Signal Level
T Shows the measured level difference (During verification &
tracking)
Evalution Shows frequency the range over which Residual Noise
results are calculated
Residual PM Shows the Residual PM result over the selected evaluation
range
Residual FM Shows the Residual FM result over the selected evaluation
range
RMS Jitter Shows the RMS Jitter result over the selected evaluation
range
Spot Noise Shows the spot noise results for the requested frequencies
and trace
Note that the Residual Noise results are displayed at the end of a measurement
sweep. Once a measurement sweep has been run changing the range for the Residual
Noise results in the General Setting view automatically updates the Residual noise
results. The range of the Residual Noise calculations is displayed in the results trace
with two lines, marker EL1 and EL2.