Specifications

R
&S
F
S-K40 Measurements & Settings
Software Manual 1161.8209.42 - 04 39
If the Verify Frequency and Level parameter is selected in the General Settings
viewthen FS-K40 will
then check to see if there is a Signal within the specified Frequency and Level
Tolerance ranges relative to the specified Signal Frequency and Level. If no Signal is
found, or a Signal is found, which is outside the tolerance range then a message will
be displayed in the status bar (“No signals found within tolerance range”) and the
measurement will be aborted.
Whilst a measurement sweep is running, changing any of the setting in the General
Settings or Meas Settings views will cause the measurement to be aborted, apart from
the following settings:
VERIFY ON/OFF
The softkey VERIFY ON/OFF toggles Frequency and level verification on and off
Remote SENS:FREQ:VER 1
TRACK LEVEL ON/OF
The softkey TRACK LEVEL ON/OFF toggles level tracking on and off
Remote SENS:POW:TRACk ON |OFF
TRACK FREQ ON/OFF
The softkey TRACK FREQ ON/OFF toggles Frequency tracking on and off
Remote SENS:FREQ:TRACk ON | OFF
PRESET SETTINGS
The softkey PRESET SETTINGS presets the option back to the default settings
Remote --
AUTOSCALE Y AXIS
The softkey AUTOSCALE Y AXIS scales the Y axis according to the trace results
Remote DISP:WIND:TRAC:Y:SCAL:AUTO ONCE
REF MEAS
The softkey REF MEAS performs a measurement and stores the trace as a reference
trace in trace 3
Remote CONF:REFM ONCE
Once a measurement sweep has been performed all active limit lines will be displayed,
with the limit result displayed.