Specifications

R
&S
F
S-K40 General Information
Software Manual 1161.8209.42 - 04 25
1.6.6.5 Entry of a numeric value
Once a parameter has been selected (see above), a new value for a numeric parameter
can be entered in a number of ways. With the exception of entry via the number keys, to
start editing the parameter, either press the ENTER key on the numeric keypad, or press
the rollkey before following the instructions below.
If an error occurs, for example, the entered value is out of range, then the new value
will not be accepted for the parameter setting.
Entry using number keys (numeric keypad)
P Enter required value using the number keys.
Example: To enter 200 MHz
2
0
0
MHz
dBm
Frequency 200 MHz
The parameter is not set to the new value until either one of the unit keys on the
numeric keypad, the ENTER or the rollkey is pressed.
If the new value is not valid, then a message box is displayed and the entered value will be
replaced with a valid value. For example, when a value above the maximum allowed is
entered, then the maximum value allowed will be shown in the entry box. The parameter
will still be ready for editing so that another value can be entered if desired.
Entry using cursor keys
P Cursor
or until obtaining the required value.
The application prevents the minimum and maximum values of the parameter from
being exceeded and displays an “Out of range“ message box if attempted.
N . B T h e c u r so r k e ys i nc r e m en t /d e c re m e nt a pa r a m e te r va l ue i n la r g e s te p s .
Example: Cursor down to 100MHz
Frequency
100 MHz
Each change of the parameter value takes place immediately. No other keys need to
be pressed.