Specifications

R
&S
F
S-K40 General Information
Software Manual 1161.8209.42 - 04 14
2. Select a single sweep measurement by pressing the SINGLE SWEEP softkey
3. Start the measurement by pressing the RUN hotkey.
During the measurement, the text "Running..." is displayed in the Status Bar at the
bottom of the screen. The progress bar will update to show progress through the
measurement sub-sweeps.
Measurement results are updated whilst the measurement is running. The results are
displayed in graphical form. Note that the trace may not be visible during a first
measurement if the trace is below the display range. Once the full measurement
sweep has completed the trace will rescale to show the trace results.