Specifications

R
&S
F
S-K40 General Information
Software Manual 1161.8209.42 - 04 13
7. Enter the start and stop frequency offsets to measure. Note that the selected range
is highlighted in the Carrier Frequency Offset table. Note also that the overall
expected measurement time is displayed at the bottom of the Carrier Frequency
Offset table.
8. Close the Measurement Settings
by pressing the PH NOISE hotkey or by pressing
ESC.
1.5.2 Performing the main measurement
Before performing a Phase Noise measurement connect the DUT to the RF Input of the
spectrum analyzer.
DUT
RF
Fig. 1 Test Setup
1. Press the SWEEP hard-key