Specifications

R
&S
F
S-K40 General Information
Software Manual 1161.8209.42 - 04 10
2. Start up the analyzer
3. Press the SETUP hardkey, followed by the GENERAL SETUP softkey and then
the OPTIONS softkey. A list of the options currently activated is displayed.
4. Press the INSTALL OPTION softkey. A Dialog is displayed allowing the option key
to be entered.
5. Enter the option key supplied with the R&S FS-K40 software.
6. When a valid option key has been supplied a dialog will be displayed explaining
that a reboot is required to complete this operation. Select OK in this dialog and
the instrument will be rebooted
7. When the analyzer starts after the reboot a new hotkey will be displayed at the
bottom of the display labelled PH NOISE. In addition an entry for the R&S FS-K40
option will be displayed in the FIRMWARE OPTIONS dialog.