Specifications

R
&S
F
S-K40 List of Warnings & Error Messages
Software Manual 1161.8209.42 - 04 108
4 List of Warnings & Error Messages
The list of possible warning & error messages are shown below :
Status Bar Message Description
Cannot run measurement - no traces are active This message is displayed when all the traces are switched off or in
VIEW mode.
Set the trace mode of atleast one trace to be
CLRWRT/AVG/MAXHOLD/MINHOLD
No signals found within tolerance range This message is only displayed when the Verify Frequency & Level
parameter is set in the General Settings view. This indicates that no
input signal could be identified within the supplied tolerances of the
specified frequency and level. Check that the Frequency and Level
parametes are set correctly. If further measurement executions give
this message then try increasing the frequency and/or level tolerance
ranges.
Frequency offset out of range:
Level out of range:
This message is similar to the above, but is displayed after the initial
verification has been successfully performed and indicates that the
current subsweep is outside tolerance.