Specifications

R
&S
F
S-K40 Remote Control
Software Manual 1161.8209.42 - 04 101
3.15.1 Description of the Status Registers
All the status registers shown in FIg. 23 are the same as those provided by the base
system, with the exception of the following:
STATus:OPERation – Although this register is provided by R&S FSP Kernel main,
R
&S FS-K40 makes use of bit 4 in this register which are not used within R&S FSP
Kernel main
STATus:QUESTionable:ACPLimit – This register is provided by the analyser and is not
available from the R&S FS-K40 command tree
STATus:QUESTionable:LIMit2 – This register is provided by the analyser and is not
available from the R&S FSQ-K40 command tree
STATus:QUESTionable:LMARgin<1|2> – These registers are provided by the analyser
and are not available from the R&S FSQ-K40 command tree
STATus:QUESTionable:SYNC – This registers is provided by the analyser and is not
available from the R&S FSQ-K40 command tree
The deviations from the status register structure of the base system are detailed below.
3.15.1.1 STATus:OPERation Register
In the CONDition part, this register contains information on which actions the instrument is
being executing or, in the EVENt part, information on which actions the instrument has
executed since the last reading. It can be read using commands
"STATus:OPERation:CONDition
?" or
"STATus:OPERation[:EVENt]?
".
Bit No Meaning
0 to 3 These bits are not used
4 MEASuring
A ‘1’ in this bit position indicates that a measurement is in progress. R&S FS-K40 only
5 to 7 These bits are not used
8 HardCOPy in progress
This bit is set while the instrument is printing a hardcopy.
9 to 14 These bits are not used
15 This bit is always 0