Specifications

R
&S
F
S-K40 Remote Control
Software Manual 1161.8209.42 - 04 91
[SENSe]:LIST:RANGe<1..20>:BWIDth[:RESolution] <numeric_value>
This command selects the resolution bandwidth (RBW) for the specified sub-band
Example
SENS:LIST:RANG2:BAND 10KHZ
'Sets the RBW to 10 KHz
Characteristics
*RST value: sub-band dependent
SCPI: conforming
[SENSe]:LIST:RANGe<1..20>:FILTer:TYPE NORMal | FFT
This command selects filter type for the specified sub-band
Example
SENS:LIST:RANG2:FILT:TYPE FFT
'Sets the filter to FFT mode
Characteristics
*RST value: sub-band dependent
SCPI: conforming
[SENSe]:LIST:RANGe<1..20>:SWEep:COUNt <numeric_value>
This command selects sweep count for the specified sub-band:
Example
SENS:LIST:RANG2:SWE:COUN 1
'Sets the sweep count to 1
Characteristics
*RST value: sub-band dependent
SCPI: conforming
[SENSe]:POWer:RLEVel:VERify[:STATe] <Boolean>
The remote control command is used to specify whether frequency and level
verification are to be performed before a phase noise measurement.
This command is synonymous with [SENSe]:FREQuency:VERify[:STATe]
Example
SENS:POW:RLEV:VER 1
'Specifies that frequency and level verification is to be
performed
Characteristics
*RST value: 1
SCPI: conforming