Specifications

R
&S
F
S-K40 Remote Control
Software Manual 1161.8209.42 - 04 89
Example
SENS:BWID:TYPE FFT
'Sets the RBW to use FFT filtering
Characteristics
*RST value: FFT
SCPI: conforming
[SENSe]:FREQuency:CENTer <numeric_value>
The remote control command is used to specify the frequency that the Analyzer
will use to make measurements against the input signal.
Example
SENS:FREQ:CENT 50MHZ
'The FS-K40 option uses the specified frequency value to set
the analyzer detection frequency.
Characteristic
*RST value: from Spectrum Analyzer
SCPI: conforming
[SENSe]:FREQuency:STARt <numeric_value>
The remote control command is used to specify the start frequency for a phase
noise measurement.
Example
SENS:FREQ:STARt 3KHZ
'Sets the start frequency for a phase noise
measurement to 3 KHz
Characteristics
*RST value: 1 kHz
SCPI: conforming
[SENSe]:FREQuency:STOp <numeric_value>
The remote control command is used to specify the stop frequency for a phase
noise measurement.
Example
SENS:FREQ:STOP 3MHZ
'Sets the start frequency for a phase noise measurement to
3 MHz
Characteristics
*RST value: 1 MHz
SCPI: conforming