Specifications

Observe the following electrical requirements:

WARNING

For proper RS-232

operation, do not apply

any voltage to pin 9.

WARNING

Disconnect DataMan from power before inserting/removing

communication modules.

Use the DM8000-RS232-02 cable (2.5 meters) or the DM8000-RS232-05 cable

(5 meters). For power supply, use the DataMan 8000 Power Supply (DM100-

PWR-000).

Power on the RS-232 cable can be supplied by either the DC Power Plug

or Pin 1 of the D-SUB. DO NOT use both in parallel.

18 DataMan 8000 Quick Reference Guide DataMan 8000 Quick Reference Guide 19

5 GND

9 Reserved

4 N/C

8 RTS

3 RxD

7 CTS

2 TxD

6 N/C

1 VCC PWR

VCC

GND

1. 6VDC power supply (DM100-PWR-000), a 5.5mm x 2.1mm DC Power

Plug

2. VCC = +4.75V up to +6.0V for 2.5 m cable

VCC = +5.5V up to +6.0V for 5.0 m cable

Connecting a DataMan 8000 through RS-232

2. With a 2 mm Allen

Wrench, tighten

the screws so

that the slide-in is

rmly locked.

3. Insert the plug and slide

the cable lock up to the

reader and twist the cable

lock in place.

1. Connect the

serial slide-

in (DMCM-

SERIALM-00) to

your DataMan

8000.

location of the

two screws