Installation guide
3.2 From X.25
The 'manager' of a Super Card may be accessed remotely from an X.25
triple-X PAD. If the X.3 parameters of the remote PAD are configurable
then the following values are recommended:
Parameter 2: 0 (echo off)
Parameter 3: 2 (packet forwarding on CR)
Parameter 4: 4 (packet forwarding on timeout)
1. Make a call using an X.121 address that matches the remote manager
address. The default subaddress is 99.
2. A welcome screen will be displayed and prompt for a password. Enter
the correct password followed by
<PF1>. The top-level menu will be
displayed.
3. If the password is incorrectly entered three times, or it takes longer than
a minute to enter it, then the call will be automatically cleared.
Refer to the relevant user guide for configuration information.
X870-300451 Issue 2 3-2 Rev.0