Installation guide

2.3 Indicators
When the 8210/8310/8325 unit is powered up, a number of indications are
displayed on the front display.
For the 8310/8325:
The green LED below the
Enter button indicates that power is on.
The status of each card is given on the LCD display. Each slot is numbered
between 1 and 5 and has three indicators:
f Fault
* Ready 2
r Ready 1
If the letter
S appears before the f, * and r indicators, it indicates that the
card installed is a Super Card.
For the Super Card:
The indicators have the following meaning:
Sf ON: Power-up tests in progress
FLASHING: Hardware failure
OFF: Normal
S* OFF: Normal
FLASHING: Diagnostic test failure
ON: Diagnostic test failure
Sr ON: Link A (port 0) 'up'
FLASHING: Link A (port 0) 'down'
OFF: No power to the card
The power-up tests are described in Section 2.6. To interpret diagnostic
failures refer to Table 2-1.
For the 8210:
The green LED (leftmost on the bottom row) indicates that power is on.
The status of each card is reflected by the two rows of LEDs (the bottom row
of LEDs reflects the status of the bottom card and likewise the top row for
the top card):
Red Fault
Yellow Ready 2
Green Ready 1
X870-300451 Issue 2 2-4 Rev.0