Specifications

X723-300151 5-26 Issue 2
Modify Format
(CCEMP) Assigned cct | Circuit ctl | Smart configs | p1 | p2 | p3 | p4 >A
port, first, last timeslot >P4
(P4,TS 1) cct = , TS control = 00000000B >A1, 10001010B
(P4,TS 2) cct = , TS control = 00000000B >A2
The first timeslot to be assigned may be selected to be TS0 to TS31. If no
first timeslot is selected, TS1 will be presented as in the example above.
This menu option also supports a block assignment mode. If values are
entered for the first and last timeslot, then only one circuit i.d. will be
requested. All timeslots in the range will then be allocated to the
designated circuit. Note that this mode should only be used for circuits
supporting multiple timeslots. The timeslots will be consecutively
allocated to the circuit. The TS control byte can not be altered without
first re-entering the circuit identity.
Display Format
(CCEDP) Assigned cct | Circuit ctl | Smart configs | p1 | p2 | p3 | p4 >A
port, first, last timeslot >P4, 10, 12
(P4,TS,10), cct = A1 , TS control = 10001010B
(P4,TS 11), cct = A2 , TS control = 00000000B
(P4,TS 12), cct = A3 , TS control = 00000000B
5.4.7 Circuit Controls
This menu command provides a facility for setting and displaying the two
control ports for the channel cards in any port. If only control port 1 is
used a value for control port 2 need not be entered. Refer to the relevant
channel card manual for control port byte values.
Modify Format
(CCEMP) Assigned cct | Circuit ctl | Smart configs | p1 | p2 | p3 | p4 >C
port, first cct >P3, A1
(P3, cct A1, TS 14), 1 = 11111011B, 2 = 11111111B > FFH
(P3, cct A2, TS 15), 1 = 11111011B, 2 = 11111111B > A5H
(P3, cct A3, TS 17), 1 = 11111011B, 2 = 11111111B > 11011011B
(P3, cct A4, TS 18), 1 = 11111011B, 2 = 11111111B > 11011101B, 10110101B
Display Format
(CCEDP) Assigned cct | Circuit ctl | Smart configs | p1 | p2 | p3 | p4 >C
port, first cct >P4 A1