Specifications

X723-300151 5-25 Issue 2
This action will cause external relay number one to be operated when the
configuration is run.
Display Format
(CCEDA) Alarm event | Route alarms | Extern relays | Card out >E
ext 1 relay Enabled
ext 2 relay Disabled
ext 3 relay Disabled
ext 4 relay Disabled
(CCEDA) Alarm event | Route alarms | Extern relays | Card out
*
>
5.4.5.4 Card Out
This allows the user to configure an alarm event to be triggered by the
removal of a card from Port 1 or Port 2
Modify Format
(CCEMA) Alarm event | Route alarms | Extern relays | Card out >C
enter start port> P1
config options 1-14 (U=unassigned)
(P1 card out) alarm config Unassigned> 1
(P2 card out) alarm config Unassigned> 1
(CCEMA) Alarm event | Route alarms | Extern relays | Card out >C
Display Format
(CCEDA) Alarm event | Route alarms | Extern relays | Card out >C
(P1 card out) alarm config 1
(P2 card out) alarm config 1
(CCEDA) Alarm event | Route alarms | Extern relays | Card out >C
5.4.6 Circuit Assignments
(CCEM) Port | sYnc | Alarms | Cross connect >P
(CCEMP) Assigned cct | Circuit ctl | Smart configs | p1 | p2 | p3 | p4 >
The 'Assigned cct' menu command provides the facility for assigning
circuits to the timeslots associated with each port and for setting the value
of the TS control byte used on VF channel cards. This value need not be
entered if the TS control port is not used, or is unchanged.