Specifications

X723-300151 5-12 Issue 2

It should be noted that 9600 is only for local Test access to the Network

Management UARTs on the System Controller and must not be used

across the network.

Each management configuration (1-14+Default) specifies one of the seven

patchfields available on the System Control cards and Dual LIU cards

fitted in ports 1 and 2. Note that the patchfields for any Dual LIUs fitted

in ports 3 and 4 are set by hardware switches. The display gives a

configuration number index across the top and by reading the relevant

column the patch selections can be determined. In order to modify the

management the entire set of 15 numbers must be entered at the relevant

line. The 'D' column specifies the patchfields selected for the default

configuration which will be run if the unit becomes un-configured due to

the backup battery becoming discharged.

Severely Errored second Limit

This sets the number of errors in any one second before it is classed as a

severely errored second. If it is set to 915, the counter will be disabled.

5.3.5 Security Password Modification

This command allows the operator to set the password utilised when in

secure mode. Note that this is a hidden menu option and requires the

operator to enter Ctrl + W - ENTER to access it.

The password is in the form of up to 8 alphanumeric characters.

(O) Set password | Display password | Password default

new password > SUNSHINE

Selecting 'Password Default' will set the password to the default which is

ENETXX where XX is the equipment identity number. Note that if the

equipment number is changed in the 'Install' menu, then 'Password

default' must be re-selected otherwise the previous number will remain as

part of the default password.