Specifications

X723-300151 5-6 Issue 2

Removing Timed Events

The operator may delete events by using the 'Remove' menu option and

specifying the event number. The specified event will be deleted and all

following events re-numbered. A consecutive range of events may be

removed by specifying the start and end event.

(T) Display | Set | Events >E

start event, end event >4,7

Enabling Timed Events

Once the timed events have been created they may be enabled using the

'Enable' menu option. The table will then be compared to the current real

time value and the correct configuration automatically run.

Disabling Timed Events

In order to gain manual or network control of the multiplexer

configuration selection, the timed events may be inhibited using the

'Disable' menu option. It is not possible to run a different configuration to

that called for by a timed event unless the events are first disabled.

Determining Current Status

The current status of the timed events can be checked using the 'Status'

menu option.

(0) timed events disabled or

(1) no current events or

timed events enabled, configuration 4 requested.

This indicates that the events are enabled and config 4 should be running.