Specifications

X723-3001510-2Issue 2
STATUTORY NOTICES
Case Communications Ltd. declare that this product conforms with the requirements of the European
Communities Council Directive of 73/23/EEC on the harmonisation of the laws of Member States to electrical
equipment designed for use within certain voltage limits.
Case Communications Ltd declare that this product conforms with the protection requirements of Council
Directive 89/336/EEC on the approximation of the laws of the member states relating to electromagnetic
protection.
This equipment has been tested using shielded cables supplied by Case Communications Ltd. These cables, or
equivalents, must be used to ensure compliance with this declaration.
All PCB assemblies contain Electrostatic Sensitive Devices (ESDs) which may be permanently damaged if
incorrectly handled. This equipment must be handled in accordance with BS5783 code of practice for the
handling of electrostatic sensitive devices.
The System Control Board DT300 contains a Nickel-Cadmium (NiCad) battery which contains toxic
substances. The following instructions must be followed when handling or disposing:
(i) Non-conductive anti-static bags must be used for transportation and storage of the board
assembly.
(ii) Care must be taken not to short-circuit the battery.
(iii) The battery must not be disposed of on an open fire.
The earth stud on the rear of the equipment must be connected to earth.
The mains powered power shelf must be connected to earth via the power lead. Protective covers on this
unit should only be removed by authorised personnel.
The DC powered power shelves must be connected to earth via the marked earth terminal.
The 3400 and 3800 must not be transported with the power supply units fitted to the chassis since this can
cause dislocation of the card guides if the unit is subjected to impact
Case Communications Limited has made all reasonable efforts to ensure the accuracy of the content of this document but the information
contained herein does not constitute a warranty of performance of the equipment and/or software described and no specifications given
form part of any contract. This document does not constitute a licence to use or copy any software described herein and any such
software must only be used in accordance with the terms of the licence supplied herewith.
Case Communications Limited reserves the right to make alterations to the equipment and software described without notice and assumes no
liability for any loss or damage caused as a result of use of this document whether because of out of date or inaccurate information or
otherwise.
Product and manufacturers' names referred to in this document are used for identification purposes only and Case Communications Limited
acknowledges the intellectual property rights of their respective owners in the same.
This document is the copyright of Case Communications Limited and may not be reproduced, copied or stored in any computerised retrieval
system by any means without the express written permission of Case Communications Limited.
Published by Case Communications Technical Publications Department