Specifications

X723-300151 6-14 Issue 2
6.2.3 Displaying Data, Signalling and Peak Codes
Data and Signalling
The 'Data' 'Display' commands allow the operator to monitor the data in a
timeslot or the signalling data in TS16 associated with a timeslot from
any of the incoming streams or ports. Data and signalling will always be
displayed in Hexadecimal.
(MDD) Data | Signalling | Peak codes >D
stream, timeslot >S2,7
70H,***,70H,
Note: while timeslot data is changing '***' will be displayed and '**' while
signalling data is changing.
The monitor points for all 'Set' and 'Display' data are shown in Figure 6-1.
Peak Codes
This command allows the peak codes for G.711 'A law' encoded speech to
be displayed. The estimated peak power level is also displayed with a
resolution of 1dB. The power displayed assumes a sinusoidal signal is
present.
(MDD) Data | Signalling | Peak codes >P
stream, timeslot >P3,19
levels (G711) power
min, max dBm0
-118 , +118, 0
-118 , +118, 0
6.2.4 Loops - Setting and Clearing
Commands are provided to allow loops to be set and cleared.
P1 or P2 may be selected for 'Local' and 'Incoming' PCM stream loops.
Timeslot local and Circuit loops will prompt for a stream or port selection
as well as the timeslot or circuit to be looped.
Positions for all loops are shown in Figure 6-1.