Specifications

X723-300151 6-13 Issue 2

Circuit Status

This menu command requests a port followed by the circuit range, and

then displays any timeslot assignments followed by the status port values

for the range specified.

(MC) sYnc | cOnfig | Alarms | Circuit status | Smart configs >C

port, first, last cct >P3,A1,A4

port (P3, A1,TS 4) status 1 11011111B, status 2 10011111B

port (P3, A2,TS 5) status 1 11111111B, status 2 10111111B

port (P3, A3,TS ) status 1 11111101B, status 2 11011111B

port (P3, A4,TS 7) status 1 10111111B, status 2 11011111B

Refer to the relevant interface card Reference manual for the

interpretation of status port byte information.

Smart Channel Card Configuration Storage

The operator may list the current storage in use for smart channel card

configurations. A Smart card may have up to 4 configurations, but if any

are the same these will only count as 1 config. Dual LIU cards in ports 1

and 2 will have 14 integrated configurations.

(MC) sYnc | cOnfig | Alarms | Circuit status | Smart configs >S

remaining storage = 86%

P1 position A DT310 allocated 14 configs.

P4 position A DT580 allocated 2 configs.

6.2.2 Setting Data and Signalling

The timeslot data and signalling can be set on the outgoing timeslots of all

streams and ports from the cross-connect awitch. Data may be set in

binary, decimal or hexadecimal with suffix B,D or H added as appropriate.

If the suffix is omitted decimal will be assumed.

(MD) Set | Display | Loops | Reconfigure >S

(MDS) Data | Signalling >D

stream, timeslot, data >P3,1,70H