Specifications

X723-300151 5-36 Issue 2

Cards must be removed from the equipment map in order to clear the map

mismatch fault after a card has been removed from the chassis. If a card

is fitted, but is not installed in the equipment map for that card slot, a

map mismatch fault will not be raised and fault logging from that card

will be inhibited.

Listing Current Map

A list of all cards mapped in or fitted is obtained by selecting 'List'.

(CE) List | Install | install All | Remove | iDent >L

Card Position Map Fitted

P1,A DT310 DT310

P2,A none none

P3,A none DT310

P3,B none none

P3,C none none

P3,D DT575 DT575

P3,E none none

P3,F none none

P4,A DT530 none

P4,B none none

P4,C none none

P4,D none none

P4,E DT579 DT579

(CE) List | Install | install All | Remove | iDent

The above mapping will cause a 'Map mismatch' alarm due to P4,A

Installing a Card

(CE) List | Install | install All | Remove | iDent >I

select port, card >P3,A

DT310 installed

(CE) List | Install | install All | Remove | iDent

Note: Installing a smart channel card in the equipment map will re-

initialise the card.