Specifications

X723-300151 5-35 Issue 2

5.4.16 Management Configuration Linking

The management menu incorporates a menu option for the linking of

management configuration changes to channel configuration changes. In

linked mode, the management configuration would be re-selected with

every new channel configuration and/or timed event change. Each

channel configuration field will run the management configuration with

the same ID number if 'link' is enabled. Under NCS control the linking of

configurations is ignored.

Setting Link Mode

0=separated 1=Linked (current = 0) >1

With configurations linked, a channel configuration change to config 8

would change the management configuration to config 8.

Setting Separate Mode

0=separated 1=Linked (current = 1) >0

In separate mode, the management configuration would only change if the

operator or network controller gave a command to do so.

When the status of the 'Link' changes from 'Separate' to 'Linked', the

management configuration will not change until the next channel

configuration change.

Checking Link Status

Link =1 management currently linked to channel config

5.4.17 Equipment Map Editing

The equipment map contains a list of the cards mapped in the system and

those actually fitted. Each card type is identified by its card identity code

on the status ports. This allows a fault to be raised, called a 'Map

mismatch' if a card is removed, or an incorrect card type is inserted.

All smart channel cards MUST be entered into the equipment map for

correct operation and should be done before configuring them.