Specifications

X723-300151 5-34 Issue 2

Display Format

(CCEDC) Fcode table | Channel assign | Multipoint | Broadcast >M

output stream, timeslot >S1

(S1, TS 1, Multipoint ,) from P3, 2, P3, 5, P4,1

(S1, TS 2, Multipoint ,) from P3, 6, P3, 7, S4,2

(S1, TS 3, Multipoint ,) from P3,18, P3, 9, P3, 23, S3, 8

Note that the first timeslot entered is displayed as the last, since it will

have the longest delay through the cross-connect switch.

5.4.13 Cross Connect Broadcast Display

In assigning output streams to source streams it is possible to obtain a

broadcast assignment. This is where one input timeslot is assigned to

more than one output timeslot. In order to be able to establish this

occurrence a 'Broadcast' display menu option is provided. When selected

this prompts for an input stream and timeslot and then lists all output

streams and timeslots assigned to it.

(CCEDC) Fcode table | Channel assign | Multipoint | Broadcast >B

input stream, timeslot >S2,6

broadcasts to outgoing S3, timeslot 9

broadcasts to outgoing P3, timeslot 5

broadcasts to outgoing S1, timeslot 18

5.4.14 Edit Buffer Origin Display

The edit buffer 'Origin' option will display the source (if known) of the data

within it. On loading the edit buffer the origin will become the number of

the configuration from which it was loaded. If it is modified a message to

this effect will be displayed. If the edit buffer is then saved, the origin will

become the number of the configuration field into which it was saved.

(CCE) Load | Save | Modify | Origin | Display >O

Edit source from configuration 4 and modified

5.4.15 Checking and Running Management Configurations

The assignment of management patchfields to configurations is set-up in

the 'mOde' - 'Install' menu.

This management menu specifies which management configuration is to

be run. Operation of the 'Current' and 'Run' commands is the same as for

the channel configuration commands.

(CM) Current | Run >