Installation Guide

NOTE: Dimming ranges from 100% to 20% brightness.

160127

Operation

TURNING LIGHTS ON, OFF

Wave hand under sensor once to turn light on or off.

DIMMING LIGHTS

Hold hand under sensor to adjust brightness.

ACTIVATING SAFE EXIT

Wave hand under sensor twice, light will flash, then

gradually dim-to-off in 1 minute.

Choose an option by sliding the switch on the surface of the sensor control. (See Fig.8 ).

When the switch is set to “ ”, the sensor is deactivated.

When the switch is set to “ ”, the sensor 's active detection range is 4" below the fixture.

When the switch is set to “ ”, the sensor 's active detection range is 8" below the fixture.

NOTE: This light fixture has a memory function.

* If the fixture is switched off, it will return to the same level of brightness when

switched on again.

Page 3 / 4

Fig.8

Function and Operation

Lock

4" 8"

Make sure the distance between cabinet lighting fixtures does not exceed the linking cord length.

NOTE: The linking cord will only plug into one end correctly. Do not try to force it into the wrong receptacle as

this could cause damage to the fixture.

NOTE: If the linking cable sags. Peel away the waxed paper on the cable clip and stick to the bottom of the under

cabinet. Fasten the linking cord with the cable clip. (See Fig. 7)

Synchronous control:

When more than two lights are connected together in series, you can interact with the motion sensor control

on any fixture in the series and the other lights will be controlled synchronously.

Dimming

Sensor Control

ON-OFF

Safe Exit Delayed Off

Label

Power Label: Hardware pack includes a "Power" label

sticker.This can be applied to the cabinet

surface above the IR detection area to serve

as a reminder for motion sensor control

location.