Installation Guide

Turn on the power at fuse or circuit box.
160127
Each additional fixture (not included) should be mounted in the same way as the first installed fixture. Once installed,
attach the linking cord between the previously installed fixture and the newly added fixture via the input
receptacles.
Page 2 / 4
Plastic Cap
Light Fixture
Light Fixture
Light Fixture
2. Remove the plastic plug on each side of the cabinet light.
(See Fig. 2)
3. Place the light fixture against the mounting surface in the
desired position and mark the location of the two key hole
slots. Remove the light fixture from the mounting surface.
Pre-drill holes in the mounting surface according to marks.
Secure the dry wall screws to the cabinet. (Do not over
tighten screws). The dry wall screw heads should protrude
approximately 1/8” (3.2mm) beyond surface to fit securely
into key hole slots. (See Fig. 3)
4. Attach the light fixture to the cabinet by inserting two dry wall
screw heads into the key holes, and sliding the light fixture
until it is locked in place. Tighten the dry wall screws if
necessary. (See Fig. 3)
5. Use a small flathead screwdriver or other similar tool to pry
off the plastic cap (marked 1) in order to connect the power
cord. (See Fig. 4)
6. Attach the link connector end of the power cord to the
receptacle (exposed by removal of the plastic cap) on the
light fixture. Plug the polarized power cord into a 120VAC
60HZ outlet. (See Fig.5)
NOTE:
1. The power cord (10 feet) has a plug on one end and
a link connector (which is marked 1) at the other end.
2. The link connector will only plug into one end correctly.
Do not try to force it into the wrong receptacle as this
could cause damage to the fixture.
Fig.2.
Dry Wall Screw
Key Hole Slot
Plastic Plug
Fig.3.
Fig.5.
Power Cord
Light Fixture
Outlet
1
Light fixture units can be connected together in series using the included 12 inch linking cord.
a. Remove the plastic caps (labeled 1 on the previously installed fixture and labeled 2 on the additional fixture) from
light fixtures before installing. (See Fig.6)
b. Units can be linked together in series from one power supply. Link up to 7 x 8" bar lights (#X0035 or X0036) together,
link up to 5 x 16" bar lights (#X0037 or X0038) together, link up to 3 x 21" bar lights (#X0039 or X0040) together, or
link combination of sizes together.
Fig.7
12˝ Linking Cord
Cable Clip
Plastic Cap
Previously
Installed
Fixture
Additional
Fixture
Previously Installed Fixture
Additional Fixture
Fig.6
Linking Multiple Fixtures:
Fig.4.