Installation Guide
TO INSTALL THE BATTERY, PRESS DOWN AND
SLIDE OUT BATTERY HOUSING COVER.
Battery Housing
Cover
1.) Make sure the electric power was turned off.
2.) Ceiling fan must be set at HIGH speed and light kit (if any) at
ON position by pulling the "Pull Switch" after installation.
3.) Once the connection has been made, the receiver inserts into
the drop rod hanging bracket. The canopy comes up to cover
the receiver and bracket. (See Fig.3)
4.) Make Wire Connection: (See Fig.4)
a. The Motor white wire to the white "To Motor N" wire from Receiver with a wire nut.
b. The Motor black wire to the black "To Motor L" wire from Receiver with a wire nut.
c. The Motor blue wire to the blue "For Light" wire from Receiver with a wire nut.
d. The white wire from Outlet Box to the red "AC in N" wire from Receiver with a wire nut.
e. The black wire from Outlet Box to the red "AC in L" wire from Receiver with a wire nut.
Make sure all of wire nuts are connected firmly.
Tuck all wire nuts and wires carefully up into the Outlet Box, EXCEPT antenna, which should
remain outside Outlet Box.
INSTALL AND MAKE WIRE CONNECTION:
TRANSMITTER
Fig.6
Fig.5
Fig.3
Fig.4
FAN/OFF
LIGHT
ON/OFF
HI
LOW
MED
5.) Install a 9V battery (not included) into the transmitter. Turn on the power, press button of
transmitter to operate the fan. (See Fig.5)
6.) Functions of Transmitter. (See Fig.6)
Hanger Ball
Receiver
a.
b.
c.
d.e.
Antenna:
Antenna
(Leave unconnected
and do not cut)
VIEW AFTER INSTALLATION
DO NOT CUT
OR SPLICE
Battery 9V
HI: Turn on the fan at high speed.
MED: Turn on the fan at medium speed.
LOW: Turn on the fan at low speed.
FAN/OFF: Turn off the fan.
LIGHT ON/OFF:
Press and release immediately to turn on or off the light.
Page 2
Wall Bracket
Transmitter
7.) Install the transmitter wall bracket in wall by two screws and hang transmitter in it carefully.
(See Fig.7)
Screw
Note:
This remote controller has memory function
setting. The fan will operate at the same
speed and the fan light will stay at the same
status as the last time the power supply was
turned off.
Fig.7
FAN/OFF
LIGHT
ON/OFF
HI
MED
LOW
Hanger Bracket