Installation Guide

180920
A: 5"
B: 20
"
C: 7-5/8
"
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Assembly Kit
5959MM (1 SET)
Glass Shade
9672CC (1 PC)
Turn on the power at fuse or circuit box.
Mounting Screw (B)
Wire Connector (E)
Mounting Plate (A)
Ball Nut (F)
Lock Nut (G)
headless Screw(D)
Green Grounding
Screw (C)
1. Thread two headless screws (D) through the mounting plate (A), then secure them with four lock nuts (G) (two on
each side of the mounting plate). Adjust the length of the headless screws (D) if necessary.
Note: Make sure that the headless screws are lined up horizontally, to ensure that the fixture will be level.
2. Attach the mounting plate (A) to the outlet box by using two mounting screws (B).
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (E) as follow:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green
grounding screw (C). Then connect it to the house grounding wire with the wire connector (E).
Carefully put the wires back into the outlet box.
4. Attach the back plate to the mounting plate (A) by inserting two headless screws (D), then secure it with two ball
nuts (F).
5. Attach the glass shade to the glass bracket, secure it with the spacer and socket ring, using supplied socket fixer.
6. Install bulb(not included). See relamping label at socket area or packaging for maximum allowed wattage.
Turn off the power at fuse or circuit box.
Installation Steps