Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0155
Turn off the power at fuse or circuit box.
141225
Page 1
Mounting Strap (A)
Short Screw (B)
Green Grounding
Screw (C)
Lock Nut (F)
Wire Nut (E)
Hardware Package (included):
Assembly Instructions:
1. Thread two long screws to the mounting strap, and secure
with two lock nuts. Adjust the length of the long screws if
necessary.
2. Attach the mounting strap to the outlet box using two short
screws.
3. Pull out the source wires from the outlet box. Make wire
connections using wire nuts as follows:
---Connect the hot wire (usually black insulation) from the
fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from
the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually bare wire) to the
mounting strap with the green grounding screw, then
connect it to the house grounding wire with a wire nut. If your
outlet box does not have a house grounding wire, then wrap
the fixture grounding wire around the green grounding screw.
Carefully put the wires back into the outlet box.
Long Screw (D)
Socket
Set screw
Ball Nut(G)
Canopy
Outlet Box
House Grounding Wire
Wire Nut (E)
Short Screw (B)
Mounting Strap (A)
Green Grounding Screw (C)
Lock Nut (F)
Long Screw (D)
Bulb Type A Max.60W
(not included)
Bottom
Glass Panel
Side Glass Panel
Side Glass
Panel
Ball Nut (G)
Metal Frame
Bottom Glass panel
“L” Slot
Metal Stop
Metal Stop
“S” Clip
“S” Clip
Fig.1
Fig.3
Fig.2
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d’alimentation principale au panneau
central de disjoncteurs avant d’installer le luminaire.