Installation Guide

141227
A: 8-3/4"
B: 19-7/8"
1. Turn off the power at fuse or circuit box before starting installation.
2. Unscrew the hex nut and washer to remove the plate from the fixture.
2. Loosen the wire nuts connected with the wires from photocell. (See Fig.2)
Note: Do not move the photocell to prevent water from seeping into the post.
3. Take a white pigtail and black pigtail and make wire connections using wire nuts: (See Fig.3)
a. The black wire from the fixture to one end of the black pigtail.
b. The white wire from the fixture to one end of the white pigtail.
c. The other end of the black pigtail to the black wire from the power source.
d. The other end of the white pigtail to the white wire from the power source.
Put all wires back into the post.
Photocell
White Wires From
Photocell
Wire Nuts
Black Wire From
Fixture
Wires From Fixture
Wires From
Main Power
Wire Nut
White Pigtail
Pigtail
Red Wires From
Photocell
Black Wires From
Photocell
Operation the Unit Without Photocell
Fig.2
Fig.3
White Wire From
Fixture
Hex Nut
Washer
Plate
4. Place the fitter on the post, then secure it with the fitter screws.
5. Attach the candle tubes onto the sockets
6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.
7. Slip the dome, bottom cover through tube to metal frame, secure them with rubber pad and hex nut, then attach top
cover to bottom cover, secure it with the finial.
Turn on the power at fuse or circuit box.
Spare Parts List:
Mounting Hardware
5162MM (1 SET)
The following parts are available for re-order if damaged or missing.
Wire Nut (B)
Fitter Screw (A)
Glass Shade
9642CS(1PC)
Candle Tube
5170DD(3PCS)