Specifications

50
① Recording
The Recording storage is managed directly; it stores data on the hard disk in real time. Five commands can be
executed, but depending on the S/W status however, some commands cannot be executed.
New
Returns the status of the selected storage device to New; if this command is executed,
the selected storage device will be moved to the {New} storage device manager.
※ Physical states supporting the execution of the commands above includes Healthy
and Warning. In Fault state, however, no command can be executed.
② Backup
The Backup storage is managed in Backup. Backup storages are not used to store data; rather, they
are only used to back up data. The user can execute only the {New} command.
Depending on the storage type of the device, the storage can be used only for (Recording) or
(Backup) purposes.
③ New
All forms of storage initially detected are displayed and managed in {New}. They can be changed into
Recording storage or Backup Storage.
Recording-Format
Changes the selected device into dedicated storage for recording
Backup-Format
Changes the selected device into a backup storage device
In {New}, at least one storage device should be selected as dedicated storage. Otherwise,
recorded data cannot be stored in real-time.
(2)Composition of the local storage device
※ There are three software status types:
Active
Connected to storage or backup device / currently saving data
Online
Only connected to storage or backup device
Offline
Not connected to storage or backup device
※ There are three hardware status types:
Healthy
Connected to storage or backup device / functioning normally
Warning
Connected to storage or backup device, but error was detected; data storage and/
or backup cannot occur (for more information, see description below).
Fault
Not connected to storage or backup device / can neither save data nor perform
backup
1.
Fault State : The storage device is damaged, and none of the S/W operations can be
performed. The fault state is not related to a DVR problem. The DVR has detected the fault
and stopped the recording.
2.
Warning State : The storage device has a physical error that can be corrected by the storage
device or by the DVR. If the error is not corrected however, the storage device is likely to be
damaged (and will shift to fault state). Backing up data in the corresponding storage device
and replacing the device with a working one are strongly recommended.
3.
If there is an active storage device with a warning or a fault, a message is displayed in the
upper-left of the screen.